| HTC P4350 Assembling | |
|
Assemble slider hinge
Align to its position
Put Slider into bottom cover
Assemble slider and fasten 6 screws
72H01701-00M
Torque: 1.1 +0.1 kg-cm
Assemble LCM and connect its FPC into RF
board
Put the RF board FPC to pass through slider hole
Maker sure FPC through the Slider
Fasten 4 screws of RF board to display bottom
cover
72H1715-00M
Torque: 0.8 +- 0.1kg-cm
Assemble receiver, put one tape to fix its wire
Fasten 4 screws on display bottom cover
72H01706-00M
Torque: 0.8 +- 0.1kg-cm
Combine keyboard upper cover with display
bezel
keyboard upper cover
(combine with FPC/Keypad Qwerty key)
Need Fixture to assemble
Fasten 6 screws of keyboard upper cover
72H1696-00M
Torque: 0.8 +- 0.1kg-cm
Assemble Camera
Pull out the slider and connect LCM FPC into MB
Then stick LCM FPC with adhesive tape, plus
one tape to fix LCM FPC
Assemble MB by inserting into ring, put MB into
keyboard upper cover and fasten one screw on
it.(below camera)
Next, fasten the keypad FPC connector
72H1715-00M
Torque: 0.8 +- 0.1kg-cm
Assemble antenna and speaker module starting
from its right lower part
Fasten 4 screws on rear side
72H01691H-00M
Torque 1.2 ± 0.1 kg-cm
Put battery in.
Set as favorite
Bookmark
Email This
Hits: 2311 Comments (0)
 Write comment
You must be logged in to post a comment. Please register if you do not have an account yet.
Older news items:
|
Subscribe to this comment's feed
